A blog full of nail design ideas for you to try on your own with step-by-step instructions and ratings for difficulty. Includes basic and more complicated designs for all abilities.
For the water marbled effect, fill a small pot with water. Drip a small amount of white nail varnish into it.
Step 3
Spray it with the drying spray as this will cause it to separate.
Step 4
Immediately dip a nail into the water, over the part of nail varnish which looks the best.
Step 5
Wait a few seconds for the nail varnish to start drying and then collect up the spare with a cocktail stick. You can then lift the finger carefully out of the water.
Step 6 Cover over the design in a top coat to protect it.
If you have any suggestions or questions, please email them to nail.art12345@gmail.com or leave a comment below. And don't forget to head over to our Facebook page and hit like!
Step 1 Paint your nails white. Between each step below, spray your nails with the Fast Dry Spray following the instructions on the can so you don't have to spend ages waiting for each layer to dry.
Step 2
Put tape on the four corners of your nails to paint a red cross one each one. Don't make it too wide or too narrow.
Step 3
Using the paintbrush, paint diagonal red lines in the four corners. Make sure they do not touch the red cross you did before.
Step 4 Using the paintbrush (clean the red off with nail varnish remover first), fill in the blue sections, leaving white around all the red. Don't worry too much about which bits of white should be thicker than others - it's too small to make much difference!
Finally, cover over the design in a top coat to protect it.
If you have any suggestions or questions, please email them to nail.art12345@gmail.com or leave a comment below. And don't forget to head over to our Facebook page and hit like!
